Non-Fabricated Parts (1 piece)

Fabricated Parts (pieces glued together)

PR12

• Pattern 12 Clear Acrylic Female Prism
• Thickness of .125" or .110"
• Maximum Stocked Panel Size 50"x 100"

PR15-200

• Pattern 15 Clear Acrylic Female Prism
• Thickness of .200"
• Maximum Stocked Panel Size 48.5"x50"

PR19-156

• Pattern 19 Clear Acrylic Male Prism
• Thickness of .156"
• Maximum Stocked Panel Size 48"x 51"

T-3060

• Nominal 1/2 X 1/2 X 1/2 White Styrene Eggcrate
• Maximum Panel Size Nominal 30"x60"

AT

• 1/2 X 1/2 X 1/2 Aluminum Eggcrate
• Maximum Panel Size 48"x 96"
• Special Order: up to 4-6 weeks lead time
• Minimum quantities may apply

AT1

• 1 X 1 X 1 Aluminum Eggcrate
• Maximum Panel Size 48"x 96"
• Special Order: up to 4-6 weeks lead time
• Minimum quantities may apply

Most plastic louvers can be fabricated to sizes over 2'x4'.

**EXCEPTION: SLP does not offer TC:
Nominal 1/2 X 1/2 X 3/8 Eggcrate larger than nominal 2'x4' **

Important Notes:

• Sagging may occur with oversized parts.

• The degree of sagging depends on the environment, material, thickness and overall size.

• SLP recommends a pre-production sample be purchased and installed to ensure fit and overall function.

____________________________________________________________________

SLP's Process

1) Shave the center walls for a proper glue seam and then cut the perimeter to size

3) Install an Add-a-Flange around the perimeter to make the piece more rigid.

4) Trim the leg of the Add-a-Flange (if required) to be unseen from below.

5) Finished Part